The SP-Elite is an 8 LED fan and should be selected as such or the SP PRO/Elite-ML Elite tag depending on whether you are using CUE 3 or 4. If this still does not resolve things, you may have a bad LED somewhere on fan 1 or 2. Try moving the first fan to position 4 or test each one at a time to find the bad LED. Good evening, Recently I bought an iCUE 465X RGB Case. It comes with 3 LL120 RGB fans and an iCUE Lighting Node CORE. Today I finished upgrading to the new case. I plugged the node in Sata Power and an USB 2.0 Header of my MB. Fans RGB are connected to the node. When I start up the PC, the LL120 fans are spinning, but the RGB isn´t working. To those that may find this in the future: The Commander Core XT is not a hot pluggable device for fans (although it seems to be for RGB). I had to disconnect the sata connector, connect the fans, and reconnect (I did not need to remove USB) After doing this, the fans were detected. This was verified with both a Corsair fan and a non-Corsair In this video I show you how to run a Commander Pro without the iCue software. Many fan and RGB controllers require buggy and bloated software like Corsair i Lighting Node PRO. 4x LL140 RGB, 140mm LED PWM Fan (Single Pack) 1x Lighting Node PRO RGB Lighting Controller with 4x RGB LED Strips. 1x RM1000i PSU. 1x H115i PRO RGB, 280mm Radiator, Liquid CPU Cooler. So PSU, CPU Cooler, 4x LED strips, 6x LED Fans, controlled by a Commander PRO and Fan Hub (from the LL140 dual pack) I should be able to So you have a bunch of RGB fans but no way of connecting them to your motherboard???? ENTER THE COMMANDER PRO Check out its features and how to install i My pump speed was shown in iCUE commander before and now it can't show up and I only can change the speed and scene of fans. I opened the case and the pump did work and I also tried to re-plug the lines on the commander core and still not working. Now in my iCUE commander core section it only shows the cooled liquid temp and the fans speed. Jun 8, 2021. jessicat1261 said: would often disconnect from Icue. It's the iCUE issue, rather than hardware issue. I too have full set of Corsair peripherals (KB, mouse, mouse pad, headset, Mar 11, 2021. #6. For me found settings curves in icue very easy and simple. Run the commander pro with 6 LL120's and have 3 other rgb connect to lighting nodes. Found same thing that default fan profiles too aggressive for my liking. Setup custom curves that make pc much happier and quiet. Have fan spin as low as 850 up to 2000rpm at 70c. Mv2K.

corsair commander pro not working